63AppendixMANUAL CEAG AUtoMAtiC tEst systEM At-s+ 40071860177 (C) December 2016 www.ceag.deAppendix B: VDE requirements for telecommunication contacts and buzzersDefault setting AT-S+Notes / CommentsDesignation Relay 1C0/14/12Relay 2C0/24/22Relay 3C0/34/32Relay 4C1/44Relay 5C1/54 BuzzerReady for operation XPermanently configured for control of a technical cabinet ventilation.Default setting >40°C ON < 35°C OFF.Ready for operation means: AT-S+ notblocked and external power source forsafety purposes ready for operationwhen detected via Z1 - Z4.Mains failure S3/S4 X Mains failure S3/S4 means: Mains fail-ure via S3 / S4 current loop detected.Mains failure DLS/3PH XMains failure DLS/3Ph means: Mainsfailure via external bus phase monitordetected.Ext. source error XExt. source error means: powersource for safety services defective(detected via Z1 - Z4).Circuit fault XCircuit fault means:Circuit fuse defectiveCircuit overloadLuminaire fault X Luminaire fault means: Faulty lumi-naireDevice fault XDevice fault means:• transmission fault• substation fault• memory card fault• fault detected via Z1 - Z4 for externalmonitor devicesISO error X ISO error means: external isolationerror detected via Z1 - Z 4.Ext. source active XExt. source active means: powersource for safety services switched on(detected via Z1 - Z4).Function testX(perma-nently con-figured)Function test means: test for testingthe luminaires. The contact switchesleading (freely configurable from 0 sto 500ms).Invert contact XInvert contact means: relay coil is noternergized for the programmed op-tionsX = active, i.e. contacts C0/14, C0/24, C0/34, C1/44 and C1/54 are closedNOTEComply with the national regulations and guidelines forindicating and signalling when using a remote switch orremote indicator for emergency lighting systems.The device has 5 floating signalling contacts (relayoutputs) and one buzzer inside the device.Signal contacts K3, K4, K5 can be freely parameterised,for each: 1 x changeover contact with common potential1 x 24V; 0.5ARelay contacts K1 (function test on), K2 (technical switch-ing cabinet ventilation) with fixed assignment, each:1 x make contact with common potential 1 x 24V; 0.5A.NO = normally openNC = normally closedContact assignment:C0/14: NOC0/12: NCC0/24: NOC0/22: NCC0/34: NOC0/32: NCC1/44: NOC1/54: NONote: