4-6 G30 Generator Protection System GE Multilin4.2 EXTENDED ENERVISTA UR SETUP FEATURES 4 HUMAN INTERFACES4The software prompts for a template password. This password must be at least four characters in length.2. Enter and re-enter the new password, then click OK to continue.The settings file template is now secured with password protection.d) VIEWING THE SETTINGS TEMPLATEOnce all necessary settings are specified for viewing, users are able to view the settings template on the online device orsettings file. There are two ways to specify the settings view with the settings template feature:• Display only those settings available for editing• Display all settings, with settings not available for editing greyed-outUse the following procedure to only display settings available for editing:3. Right-click the device in the Online or Offline Window area and apply the template by selecting the Template Mode >View In Template Mode option.4. Enter the template password then click OK to apply the template.Once the template has been applied, users are limited to view and edit the settings specified by the template. The effect ofapplying the template to the phase time overcurrent settings is shown below.Figure 4–4: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE COMMANDPhase time overcurrent settings window without template applied.Phase time overcurrent window with template applied viathe command.The template specifies that only the andsettings be available.Template Mode > View In Template ModePickup Curve842858A1.CDR
