5-98 G30 Generator Protection System GE Multilin5.2 PRODUCT SETUP 5 SETTINGS55.2.18 INSTALLATIONPATH: SETTINGS PRODUCT SETUP INSTALLATIONTo safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any outputrelay until RELAY SETTINGS is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. TheUNIT NOT PROGRAMMED self-test error message is displayed until the relay is put into the "Programmed" state.The RELAY NAME setting allows the user to uniquely identify a relay. This name will appear on generated reports. INSTALLATIONRELAY SETTINGS:Not ProgrammedRange: Not Programmed, ProgrammedMESSAGE RELAY NAME:Relay-1Range: up to 20 alphanumeric characters
