Operation Manual – SNMP-RMONH3C S5500-EI Series Ethernet Switches Chapter 2 RMON Configuration2-6To do… Use the command… RemarksDisplay RMON prialarmconfiguration informationdisplay rmon prialarm[ entry-number ]Available inany viewDisplay RMON eventsconfiguration informationdisplay rmon event[ entry-number ]Available inany viewDisplay RMON event loginformationdisplay rmon eventlog[ event-number ]Available inany view2.4 RMON Configuration ExampleI. Network requirementsAgent is connected to a configuration terminal through its console port and to a remoteNMS across the Internet.Create an entry in the RMON Ethernet statistics table to gather statistics onGigabitEthernet 1/0/1, and logging is enabled after received bytes exceed the specifiedthreshold.II. Network diagramFigure 2-1 Network diagram for RMON (on a switch)III. Configuration procedure# Configure RMON to gather statistics for interface GigabitEthernet 1/0/1. system-view[Sysname] interface GigabitEthernet 1/0/1[Sysname-GigabitEthernet 1/0/1] rmon statistics 1 owner user1-rmon[Sysname-GigabitEthernet 1/0/1] quit# Display RMON statistics for interface GigabitEthernet 1/0/1. display rmon statistics GigabitEthernet 1/0/1Statistics entry 1 owned by user1-rmon is VALID.Interface : GigabitEthernet1/0/1etherStatsOctets : 0 , etherStatsPkts : 0etherStatsBroadcastPkts : 0 , etherStatsMulticastPkts : 0
