Operation Manual – IPv6 RoutingH3C S5500-EI Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration3-93.5.6 Configuring a Priority for OSPFv3A router may run multiple routing protocols. The system assigns a priority for eachprotocol. When these routing protocols find the same route, the route found by theprotocol with the highest priority is selected.Follow these steps to configure a priority for OSPFv3:To do... Use the command... RemarksEnter system view system-view —Enter OSPFv3 view ospfv3 [ process-id ] —Configure a priority forOSPFv3preference [ ase ][ route-policyroute-policy-name ]preferenceOptionalBy default, the priority ofOSPFv3 interval routes is 10,and priority of OSPFv3external routes is 150.3.5.7 Configuring OSPFv3 Route RedistributionFollow these steps to configure OSPFv3 route redistribution:To do... Use the command... RemarksEnter system view system-view —Enter OSPFv3 view ospfv3 [ process-id ] —Specify a default cost forredistributed routes default cost value OptionalDefaults to 1Redistribute routes fromanother protocolimport-route { isisv6process-id | ospfv3process-id | ripngprocess-id | bgp4+[ allow-ibgp ] | direct |static } [ cost value | typetype | route-policyroute-policy-name ] *RequiredNot configured by defaultConfigure the filtering ofoutgoing redistributedroutesfilter-policy{ acl6-number |ipv6-prefixipv6-prefix-name } export[ isisv6 process-id |ospfv3 process-id | ripngprocess-id | bgp4+ |direct | static ]OptionalNot configured by default
