Operation Manual – IPv6 RoutingH3C S5500-EI Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration3-4Task RemarksConfiguring OSPFv3 Basic Functions RequiredConfiguring an OSPFv3 Stub Area OptionalConfiguring OSPFv3Area Parameters Configuring OSPFv3 Virtual Links OptionalConfiguring OSPFv3 RouteSummarization OptionalConfiguring OSPFv3 Inbound RouteFiltering OptionalConfiguring Link Costs for OSPFv3Interfaces OptionalConfiguring the Maximum Number ofOSPFv3 Load-balanced Routes OptionalConfiguring a Priority for OSPFv3 OptionalConfiguring OSPFv3Routing InformationManagementConfiguring OSPFv3 RouteRedistribution OptionalConfiguring OSPFv3 Timers OptionalConfiguring the DR Priority for anInterface OptionalIgnoring MTU Check for DD Packets OptionalDisable Interfaces from SendingOSPFv3 Packets OptionalTuning and Optimizingan OSPFv3 NetworkEnable the Logging on Neighbor StateChanges Optional3.3 Configuring OSPFv3 Basic Functions3.3.1 Prerequisitesz Make neighboring nodes accessible with each other at network layer.z Enable IPv6 packet forwarding3.3.2 Configuring OSPFv3 Basic FunctionsFollow these steps to configure OSPFv3 basic functions:To do... Use the command... RemarksEnter system view system-view —Enable OSPFv3 andenter its view ospfv3 [ process-id ] RequiredSpecify a router ID router-id router-id Required
