Operation Manual – System Maintaining and DebuggingH3C S5500-EI Series Ethernet Switches Chapter 2 System Maintaining and Debugging2-4To do… Use the command… Remarkstracert [ -a source-ip | -ffirst-ttl | -m max-ttl | -p port| -q packet-number | -wtimeout ] * remote-systemOptionalUsed in IPv4 networkAvailable in any viewView the routes from thesource to the destination tracert ipv6 [ -f first-ttl |-m max-ttl | -p port | -qpacket-number | -wtimeout ] * remote-systemOptionalUsed in IPv6 networkAvailable in any viewNote:z For a low-speed network, you are recommended to set a larger value for the timeouttimer (indicated by the -t parameter in the command) when configuring the pingcommand.z Only the directly connected segment address can be pinged if the outgoing interfaceis specified with the -i argument.2.2.2 System DebuggingTo do… Use the command… RemarksEnable the terminalmonitoring of systeminformationterminal monitorOptionalThe terminal monitoringon the console is enabledby default and that on themonitoring terminal isdisabled by default.Enable the terminaldisplay of debugginginformationterminal debuggingRequiredDisabled by defaultAvailable in user viewEnable debugging for aspecified moduledebugging { all [ timeouttime ] | module-name[ option ] }RequiredDisabled by defaultAvailable in user viewDisplay the enableddebugging functionsdisplay debugging[ interface interface-typeinterface-number ][ module-name ]OptionalAvailable in any view
