Operation Manual – DLDPH3C S5500-EI Series Ethernet Switches Chapter 1 DLDP Configuration1-15To do… Use the command… RemarksEnter system view system-view —EnterEthernetport viewinterface interface-typeinterface-numberEnterEthernetportview/portgroupviewEnterportgroupviewport-group { aggregationagg-id | manualport-group-name }Either is required.The configurationperformed in Ethernet portview applies to the currentport only; the configurationperformed in port groupview applies to all the portsin the port group.Reset DLDP state dldp reset Required1.3 Displaying and Maintaining DLDPTo do… Use the command… RemarksDisplay the DLDPconfiguration of a portdisplay dldp [ interface-typeinterface-number ] Available in any viewDisplay the statisticson DLDP packetspassing through a portdisplay dldp statistics[ interface-typeinterface-number ]Available in any viewClear the statistics onDLDP packetspassing through a portreset dldp statistics[ interface-typeinterface-number ]Available in user view1.4 DLDP Configuration Example1.4.1 DLDP Configuration ExampleI. Network requirementsz Device A and Device B are connected through two fiber pairs, in which two fibersare cross-connected, as shown in Figure 1-4.z It is desired that the unidirectional links can be disconnected on being detected;and the ports shut down by DLDP can be restored after the fiber connections arecorrected.
