Operation Manual – MulticastH3C S5500-EI Series Ethernet Switches Chapter 3 MLD Snooping Configuration3-276) Verify the configuration# View the detailed information about MLD Snooping multicast groups in VLAN 100 onSwitch A.[SwitchA] display mld-snooping group vlan 100 verboseTotal 1 IP Group(s).Total 1 IP Source(s).Total 1 MAC Group(s).Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy portSubvlan flags: R-Real VLAN, C-Copy VLANVlan(id):100.Total 1 IP Group(s).Total 1 IP Source(s).Total 1 MAC Group(s).Router port(s):total 2 port.GE1/0/1 (D) ( 00:01:30 )GE1/0/3 (S)IP group(s):the following ip group(s) match to one mac group.IP group address:FF1E::101(::, FF1E::101):Attribute: Host PortHost port(s):total 1 port.GE1/0/2 (D) ( 00:03:23 )MAC group(s):MAC group address:3333-0000-0101Host port(s):total 1 port.GE1/0/2As shown above, GigabitEthernet 1/0/3 of Switch A has become a static router port.3.8.3 MLD Snooping Querier ConfigurationI. Network requirementsz As shown in Figure 2-5, in a Layer-2-only network environment, Switch C isattached to the multicast source (Source) through GigabitEthernet 1/0/3. At leastone receiver is connected to Switch B and Switch C respectively.z MLDv1 is enabled on all the receivers. Switch A, Switch B, and Switch C run MLDSnooping. Switch A acts as the MLD Snooping querier.
