Operation Manual – RRPPH3C S5500-EI Series Ethernet Switches Chapter 1 RRPP Configuration1-18[Sysname-GigabitEthernet1/0/2] link-delay 0[Sysname-GigabitEthernet1/0/2] quit[Sysname] interface gigabitethernet 1/0/4[Sysname-GigabitEthernet1/0/4] link-delay 0[Sysname-GigabitEthernet1/0/4] quit[Sysname] rrpp domain 1[Sysname-rrpp-domain1] control-vlan 4092[Sysname-rrpp-domain1] ring 1 node-mode transit primary-port gigabitethernet1/0/1 secondary-port gigabitethernet 1/0/2 level 0[Sysname-rrpp-domain1] ring 2 node-mode assistant-edge common-portgigabitethernet 1/0/2 edge-port gigabitethernet 1/0/4[Sysname-rrpp-domain1] ring 1 enable[Sysname-rrpp-domain1] ring 2 enable[Sysname-rrpp-domain1] quit[Sysname] rrpp enable1.7 Displaying and Maintaining RRPPTo do… Use the command… RemarksDisplay brief informationabout RRPP configuration display rrpp briefDisplay detailedinformation about RRPPconfigurationdisplay rrpp verbose domaindomain-id [ ring ring-id ]Display RRPP statistics display rrpp statistics domaindomain-id [ ring ring-id ]Available inany viewClear RRPP statistics reset rrpp statistics domaindomain-id [ ring ring-id ]Available inuser view1.8 RRPP Typical Configuration ExamplesThis section covers these topics:z Configuring Single Ring Topologyz Configuring Intersecting Ring Topology1.8.1 Configuring Single Ring TopologyI. Networking requirementsz Device A, Device B, Device C and Device D constitute RRPP domain 1;z Specify the control VLAN of RRPP domain 1 as VLAN 4092;z Device A, Device B, Device C and Device D constitute primary ring 1;
