The ’Supplemental Restart Policy’, if enabled, is used when the O/S Defined RestartPolicy is undefined, or is set to False.When surveillance detects operating system inactivity during restart, an enabled’Supplemental Restart Policy’ causes a system reset and the reboot process begins.v Call-Out Before Restart(on/off)When enabled, Call-Out Before Restart allows the system to call out (on a serial portthat is enabled for call out) when an operating system restart is initiated. Such callscan be valuable if the number of these events becomes excessive, thus signallingbigger problems.v Enable Unattended Start Mode (1=Yes, 0=No)When enabled, ’Unattended Start Mode’ allows the system to recover from the lossof ac power.If the system was powered on when the ac loss occurred, the system reboots whenpower is restored. If the system was powered off when the ac loss occurred, thesystem remains off when power is restored.You can access this service aid directly from the AIX command line by typing:/usr/lpp/diagnostics/bin/uspchrp -bConfigure Remote Maintenance PolicyThe Remote Maintenance Policy includes modem configurations and phone numbers touse for remote maintenance support. Use this service aid to display and change thefollowing settings for the Remote Maintenance Policy.Note: Some of the following settings may not be displayed by this service aid.v Configuration File for Modem on S1 Configuration File for Modem on S2Enter the name of a modem configuration file to load on either serial port 1 (S1) orserial port 2 (S2). The modem configuration files are located in the directory/usr/share/modems. If a modem file is already loaded, a Modem file currentlyloaded message displays.v Modem file currently loaded on S1 Modem file currently loaded on S2This is the name of the file that is currently loaded on serial port 1 or serial port 2.Note: These settings are only shown when a modem file is loaded for a serial port.v Call In Authorized on S1 (on/off) Call In Authorized on S2 (on/off)Call In allows the Service Processor to receive a call from a remote terminal.v Call Out Authorized on S1 (on/off) Call Out Authorized on S2 (on/off)Call Out allows the Service Processor to place calls for maintenance.v S1 Line Speed S2 Line SpeedA list of line speeds is available by using ’List’ on the screen.v Service Center Phone NumberTelephone number of the service center computer. The service center usuallyincludes a computer that takes calls from systems with call-out capability. This118 User’s Guide
