system initialization indicators displayed on the screen, the system would enter theOpen Firmware prompt and disregards the settings in the Boot Mode Menu.Note: After the logo screen displays, the initialization indicators display across thebottom of the screen. The system initialization indicators are described in“Open Firmware” on page 105. The user can tell also by the initializationindicators that appear on the operator panel; watch for the code E1F1.v Ring Indicate Power-On MenuRing Indicate Power-On is an alternate method of dialing in, without establishing aservice processor session. If the system is powered off and Ring Indicate Power-Onis enabled, the server is powered on at the predetermined number of rings, If theserver is already on, no action is taken. In either case, the telephone call is notanswered. The caller receives no feedback that the server is powered on. The RingIndicate Power-On Menu and defaults are shown below:Ring Indicate Power-On Menu1. Ring indicate power-on:Currently Disabled2. Number of rings:Currently 698. Return to Previous MenuThe number of rings can be set to any number greater than zero.v Reboot/Restart Policy Setup Menu, see “Reboot/Restart Policy Setup Menu” onpage 58.v Power-On SystemAllows immediate power-on of the system. For other power-on methods, see “SystemPower-On Methods” on page 61.v Power-Off SystemAllows the user to power-off the server following a surveillance failure.System Information MenuThis menu provides access to system configuration information, error logs, systemresources, and processor configuration.50 User’s Guide
