8-88 SCANS■ ∂F scan ∂F scan scans a small range of frequencies around anoperating frequency. ∂F scan center frequency can beset as specific frequency or as the operating frequency.DD Settingq Push [EXIT/SET] several times to close a multifunc-tion screen, if necessary.w Push [F-5•SCAN] to select scan setting screen.e Push [F-3•∂F] once to enter the center frequencysetting.r Rotate the main dial to select the ∂F scan centerfrequency to fixed frequency or variable frequency.• Displayed frequency can be changed using the keypad.• When fixed frequency is selected, frequency appears.When variable frequency is selected,“---,---,--- MHz” ap-pears.t Push [F-3•∂F] then rotate the main dial to set the∂F span.• ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz,±500 kHz and ±1000 kHz are selectable.y Push [F-3•∂F] to set the ∂F scan.[F-2•:F] [EXIT/SET] Main dialDD ∂∂F scan operationq Push [EXIT/SET] several times to close a multifunc-tion screen, if necessary.w Select the desired VFO or memory channel.e Select the desired operating mode.• The operating mode can also be changed while scan-ning.r Set [SQUELCH] control open or closed.• See page 9-2 for squelch condition.t Push [∂F] to start the ∂F scan.• Scan screen appears.• “ ” and decimal points blink while scanning.• When the center frequency is fixed and the operatingfrequency exceeds the scanning range, ∂F scan jumpsto the fixed center frequency.y When the scan detects a signal, the scan stops,pauses or ignores it depending on the resume set-ting and the squelch condition.u To cancel the scan, push [∂F].• Pushing [F5•STOP] also cancels the scan.• Pushing [EXIT/SET] closes the scan screen.i Push and hold [F-6•RECALL] for 1 sec. to recall thefrequency that was set before starting the scan, ifdesired.:F SCANScan indicator and ∂F scan indicator appear[EXIT/SET][SQUELCH] [:F]
