8-158SCANS■ Skip scan You can set the selected memory channel as a skipchannel which is skipped during memory scan. Its fre-quency is also skipped during programmed and automemory write scans. This setting is useful to speed upthe scan speed.DD Specifying skip channelsq Push [EXIT/SET] several times to close a multifunc-tion screen, if necessary.w Push [F-4•MEMORY] to select memory list screen.e While pushing and holding [F-1•ROLL] or [F-2•SET],rotate the main dial to select the memory channel tobe specified as a skip channel.• [M-CH] (or [BANK]) control and direct keypad selectioncan be used.r Push [F-5•SKIP] to select the skip setting ON.• “SKIP” indicator appears.• Push [F-5•SKIP] again to select the skip setting OFF.t Repeat steps e to r to program another memorychannel as a skip channel, if desired.y Push [EXIT/SET] to exit the memory list screen.DD Programming skip frequencies (for programming scan)q Start programming scan as described on page 8-7.w When the scan pauses on an undesired signal, pushand hold [MW] for 1 sec.• The frequency is memorized into the skip bank as a skipfrequency.DD Skip scan settingq Push [F-5•SCAN] to select scan screen.w Push [F-7•SET] to select scan set mode.e Push [F-1•Y] to select “SKIP Function.”r Rotate the main dial to select the desired condition.• Push and hold [F-4•DEF] for 1 sec. to select the defaultsetting.t Push [EXIT/SET] to return to scan menu.[F-1•Y] [F-4•DEF] [EXIT/SET] Main dial[MW]
