                                                                                                                                                                | |
Contents
|
AV1Basic Operation2-54 ANALOG AUDIO INPUT CONNECTORSProvide analog audio input. Eight stereo analog audio input con-nectors labeled 1 to 8 are available. Connectors labeled 3, 4, 5, 6, 7and 8 can be configured as 5.1-channel connectors.When a 5.1-channel analog audio source is present, input signals aresent to the audio output connectors as indicated in the table below.5 AUDIO OUTPUT CONNECTORSProvide analog audio output. Eight connectors, labeled Front L/R, Cen-ter, Subwoofer, Side L/R and Rear L/R are available.6 VIDEO INPUT CONNECTORSProvide video input. Five composite video connectors labeled Video1 to 5, five S-video connectors labeled S-Video 1 to 5, and threecomponent video connectors labeled 1 to 3 are available.7 VIDEO OUTPUT CONNECTORSProvide video output. One composite video connector, one S-videoconnector, and one component video connector are available.Note:• Composite video output connectors are available when a compositesource is present.• S-video output connectors are available when an S-video source ispresent.• Component video output connectors are available when a compo-nent, composite or S-video source is present.8 IR IN CONNECTORAccepts input of IR signals from infrared distribution equipment.One 3.5mm jack that accepts a stereo plug (Tip/Ring connection)or mono plug (Tip/Sleeve connection) is available.9 RS-232 CONNECTORSThe RS-232 serial connector (1) is used to perform configuration down-loads and flash memory software upgrades. The RS-232 connector (2) iscapable of supporting future developments.10 TRIGGER OUTPUT CONNECTORSThe AV1 is equipped with one 5-pin DIN connector, which provides three12V DC outputs for controlling compatible components. The figurebelow shows how the connector is configured. The Power Trigger pin isnot user programmable, Trigger (1) is user programmable, Trigger (2) isan inverted sense from Trigger (1) and is not independently programma-ble. The Power Trigger is “on” when the AV1 is not in Standby and is “off”when the AVI is in Standby or powered down. Trigger (1) is user config-urable by remote control, Input Selection, or Mode Selection. See“TriggerSetup” on page 3-52 for more information.Input Connector Output Connector(L) Front L(R) Front R(C) Center(SUB) Subwoofer(LS) Side L and Rear L(RS) Side R and Rear RTrigger 2Trigger 1Power Trigger GroundGround |
Related manuals for JBL Performance AV1
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine