Basic OperationJBL Performance2-18DIGITAL STATUSProvides information about digital input sources for which a samplerate is detected, but no audio is present in the input signal.See“Status Menu Parameter Descriptions” on page 3-18 for detailed information.STATUS MENU PARAMETER DESCRIPTIONS2.0 ENCODING MATRIX, NONEIndicates whether or not a matrix-encoded source is detected.When the parameter setting is MATRIX, a matrix-encoded source isdetected. When the parameter setting is NONE, a matrix-encodedsource is not detected. The AV1 cannot automatically detect matrixencoding in non-flagged input sources.BIT RATE 32kbps to 640 kbps or 754kbps to 1509.7kbpsIndicates the rate at which the input signal is encoded. A higher bit rateindicates that less compression was used during the encoding process.Possible settings for Dolby Digital sources range from 32 to 640 kbps.Possible settings for DTS(-ES) sources range from 754 to 1509.7kbps.CENTER MIX LVL -3.0dB, -4.5dB, -6.0dBIndicates the relative level of the center channel that was used dur-ing the mixing process.CHANNELS 3/3.1, 3/2.1, 3/2, 3/1, 2/2, 2/1, 2/0, 1/0Indicates the number of channels present in the input source. Thefirst digit indicates the number of front channels present. The digitafter the slash indicates the number of surround channels present.The digit after the decimal point indicates the presence of LFE (lowfrequency effects) information. For instance, if the parameter set-ting is 3/2.1, an input source with three front channels, two sur-round channels, and LFE information is present. LFE information issent to the audio output connector labeled Subwoofer.Parameter Possible SettingsINPUT The selected inputMODE The activated listening modeINPUT TYPE ---SAMPLE RATE 44.1kHz, 48kHz, 88.2kHz, 96kHzDIGITAL STATUSINPUTMODEINPUT TYPESAMPLE RATE