SetupJBL Performance3-24SPEAKER SETUPSelecting the SETUP menu SPEAKERS option opens the SPEAKER SETUP menu, which can be used to configure the audio output connectors forthe desired speaker setup, set speaker distances and calibrate output levels. The AV1 has eight audio output connectors labeled Front L/R, Cen-ter, Subwoofer, Side L/R and Rear L/R.CUSTOM SPEAKER SETUPSSelecting the SPEAKER SETUP menu CUSTOM SETUP option opensthe CUSTOM SETUP menu, which is used to configure the audiooutput connectors for a custom speaker setup. The CUSTOMSETUP menu allows the selection of independent crossover pointsfor each audio output connector.DETERMINING CROSSOVER POINTSThe CUSTOM SETUP menu allows independent crossover points tobe assigned for each audio output connector. Crossover points areselected in 10Hz increments within a 30Hz to 120Hz range. Withthe exception of THX 80Hz, all crossover points activate a 24dBper-octave filter. The graphs on the next page indicate the fre-quency response of these crossover points.The THX 80Hz crossover point activates a 12dB per-octave filter forthe audio output connectors labeled Front L/R, Center, Side L/Rand Rear L/R, and a 24dB-per-octave filter for the audio outputconnector labeled Subwoofer.For each audio output connector, select the crossover point closestto the low-frequency rating of the associated speaker. For the out-put connector labeled Subwoofer, select the crossover point equalto the lowest crossover point of the other speakers.SPEAKERSSETUP SPEAKER SETUPSPEAKER SETUPCUSTOM SETUPTHX SETUPSPEAKER DISTANCESLEVELS CALIBRATIONCR SR RRL SL RLMSUB40Hz 60Hz 60Hz60Hz40Hz 40Hz 60Hz 60HzMAIN MENUMODE ADJUSTAUDIO CONTROLSSETUPSETUPINPUTSSPEAKERSREAR PANEL CONFIGDISPLAYSVOLUME CONTROLSTRIGGERLOCK OPTIONSCUSTOM SETUPFRONT L/RCENTERSIDE L/RREAR L/RSUBWOOFERULTRA2 SUBBGCASA40 Hz60 Hz60 Hz60 Hz40 HzOFFN/AAPARTSPEAKERSSETUP CUSTOM SETUP