Keith McMillen Instruments K-MIX User Manual
Also see for K-MIX: Quick start guide
                                                                                                                                                            | |
Contents
| 
K-M IX E DITOR1065.2.1.2 – A UX O UTPUT C HANNEL S TRIPThe Aux Output Channel Strips are where parameters related to the aux output busses are located. Thepanning, send level, and pre/post switch for each input channel is available in the aux channel strips.These parameters are also available in the routing section of the Input Channel Strips, but the auxchannel strips allow you to see the settings for all eight input channels simultaneously.To access one of the Aux Output Channel Strips, simply click one of the channel select buttons abovethe Aux Output Faders (in the editor). The editor will automatically display the appropriate channel stripin the main tab area.P AN K NOBSThe aux pan knobs set the left/right panning of the signal going to the selected aux output bus.• Full left (counterclockwise) sends to just the odd-numbered output — output 3 for aux 1, output5 for aux 2, and output 7 for aux 3.• Full right (clockwise) sends to just the even-numbered output — output 4 for aux 1, output 6 foraux 2, and output 8 for aux 3.• A centered pan knob will send the channel’s signal to both outputs of the aux pair equally.S END L EVEL F ADERSThe aux send level faders control the amount of signal being sent to the selected aux outputchannels.• Raise a fader to increase the signal being sent to the aux output; lower the fader to decreasethe signal being sent to the aux output.AUX 1 SENDS-6.52 dBPanCH. 1SendLevelPOST-6.52 dBPanCH. 2SendLevelPOST-6.52 dBPanCH. 3SendLevelPOST-6.52 dBPanCH. 4SendLevelPOST-6.52 dBPanCH. 5SendLevelPOST-6.52 dBPanCH. 6SendLevelPOST-6.52 dBPanCH. 7SendLevelPOST-6.52 dBPanCH. 8SendLevelPOST |
Related manuals for Keith McMillen Instruments K-MIX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine