Keith McMillen Instruments K-MIX User Manual
Also see for K-MIX: Quick start guide
                                                                                                                                                            | |
Contents
| 
K-M IX H ARDWARE454.2.4 – F INEThe [FINE] button is used to turn fine-tuning on and off, allowing for extra precision whenadjusting parameters. This essentially “zooms in” on the current rotary and fader positions.4.2.4.1 – F INE -T UNING T HE F ADERSTo fine-tune a fader parameter, do the following:1. Press and release the [FINE] button to toggle Fine-Tuning Mode on. The fader LEDs will instantlymove to the center of the fader; this represents the original “coarse” value.2. Move the fader up from center to increase the parameter’s value with extra precision.3. Move the fader down from center to decrease the parameter’s value with extra precision.4. Press the [FINE] button to exit fine-tuning mode. The fader LEDs will go back to their normalappearance.5. If you need to go further than the range offered by fine-tuning mode, you can repeat steps 1–4again to reset the center point to the new value.4.2.4.2 – F INE -T UNING T HE R OTARIESTo fine-tune a rotary parameter, do the following:1. Press the [FINE] button to toggle fine-tuning mode on. The rotary LEDs will instantly move to the 12o’clock position — this represents the original “coarse” value.2. Move the rotary clockwise to increase the parameter’s value with extra precision.3. Move the rotary counterclockwise to decrease the parameter’s value with extra precision.4. Press the [FINE] button to exit fine-tuning mode. The rotary LEDs will go back to their normalappearance.It is important to note that when fine-tuning the rotaries they act as “endless encoders” — you can keepmoving them around and around in the same direction as much as you want. This is unlike their normalbehavior, which is restricted to movement between the 7 o’clock and 5 o’clock position, similar to atraditional knob.Depending on the mode your K-Mix is currently in, some faders may not becontrolling a mixer function. If this is the case, fine-tuning will not work for thosefaders and their LEDs will be off.Depending on the mode your K-Mix is currently in, some rotaries may not becontrolling a mixer function. If this is the case, fine-tuning will not work for thoserotaries and their LEDs will be off. |
Related manuals for Keith McMillen Instruments K-MIX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine