K-M IX E DITOR1135.2.3.1 – S URROUND O N /O FF S WITCHEnables or disables surround panning.• Click to toggle the on/off state.• When surround panning is enabled, the switch will light up magenta.• When surround panning is disabled, the switch will be dark.5.2.3.2 – S PEAKER L AYOUT S ELECTORSelects the surround speaker format that will be used to output audio when surround panning isenabled. The surround modes offered are as follows:• All surround formats begin with speaker 1 at the front-left position and increment clockwise. Thismay run contrary to established 5.1 and 7.1 film standards, but it makes plugging output channelsinto the appropriate speakers much easier.5.2.3.3 – B ASS M ANAGEMENTThe Bass Management section of the Surround tab contains options for configuring the optional lowfrequency crossover when surround panning is enabled.• When bass management is enabled (and surround panning), all low frequency content (audiobelow the crossover frequency) will be routed out the headphone jack; higher frequency content(audio above the crossover frequency) will go out outputs 1–8 as normal.When surround panning is enabled, the Aux sends, Aux panning, and Aux fadersno longer function as normal. Aux outputs are used exclusively for surround outputchannels, even if the current surround format does not use all outputs (e.g. the“Quad” surround format).Quad81 234567OCTAGON22.5º67.5º112.5-67.5º-112.5157.5-22.5º-157.51 325 45.130º0º-30º110º-110ºSUB (BASS MANAGEMENT MUST BE ENABLED)1 234QUAD45º135º-135º-45º 1 3267 457.1SUB (BASS MANAGEMENT MUST BE ENABLED)30º150º0º-30º-150º110º-110ºSUB (BASS MANAGEMENT MUST BE ENABLED)SUB (BASS MANAGEMENT MUST BE ENABLED)This is an editor-only parameter. It may not be adjusted from the mixer.OFF 40 Hz