K-M IX E DITOR107P RE /P OST S WITCHESThe aux pre/post switches set whether audio is going to the aux outputs pre-fader or post-fader. Theaudio is either tapped before or after the input channel’s volume fader.• When set to “Pre”, the currently selected channel’s volume fader will have no effect on the levelgoing to the aux; the send level fader will be the only level control.• When set to “Post”, the currently selected channel’s volume fader will have an effect on theaudio going to the aux. Both the send level fader and the input channel’s volume fader are incontrol of audio going to the aux. If the send level fader is all the way up, but the volume faderfor the selected channel is all the way down (or muted), no audio will be sent to the auxes.5.2.1.3 – P HONES C HANNEL S TRIPThe Phones Channel Strip is where the headphone output monitoring point is set.To access the Phones Channel Strip, simply click the channel select button above the Phones OutputFader. The editor will automatically display the appropriate channel strip in the main tab area.P HONES O UTPUT A SSIGNMENTThese switches allow you to set your K-Mix’s headphone output to monitor any of the four stereooutput busses, any of the eight input channels, or have it act as a discrete stereo output.• Main = Monitoring outputs 1 & 2• Aux 1 = Monitoring outputs 3 & 4• Aux 2 = Monitoring outputs 5 & 6Regardless of how the pre/post switch is set, the audio will always be post-DSPeffects (EQ, gate, compressor). Please refer to the K-Mix Signal Flow Diagram to seeexactly where the audio is tapped.PHONES MONITOR SELECTMAINDISCRETE STEREO OUTPUTAUX 1 AUX 2 AUX 3CH. 1 CH. 2 CH. 3 CH. 4CH. 5 CH. 6 CH. 7 CH. 8