Keith McMillen Instruments K-MIX User Manual
Also see for K-MIX: Quick start guide
                                                                                                                                                            | |
Contents
| 
K-M IX H ARDWARE674.2.17 – T RIMThe [TRIM] button is used to enter K-Mix’s “Trim Mode” — here you can adjust the input trimlevels for input channels 1–8.4.2.17.1 – W HAT D O T HE C ONTROLS D O ?F ADER B EHAVIORIn Trim Mode, faders 1–8 are used to control the amount of trim (or “gain”) to apply to input signals.• Move a fader up to increase the trim level for that channel.• Move a fader down to decrease the trim level for that channel.The master fader is not used in Trim Mode; it will not respond to touch and its LEDs will be off.R OTARY B EHAVIORThe rotaries are not used in Trims Mode; they will not respond to touch and their LEDs will be off.C HANNEL S ELECT B UTTON B EHAVIORThe channel select buttons are not used in Trims Mode; they will not respond to touch and theirLEDs will be off.4.2.17.2 – A DJUSTING T RIM L EVELSTo adjust the input trim levels, do the following:1. Press the [TRIM] button to enter Trim Mode.2. Adjust faders 1–8 to set the trim level for each of the 8 input channels. Moving a fader up increasesthe trim level, moving it down decreases the trim level.Also note that input channels 1–2 have different trim ranges than input channels 3–8. The ranges are asfollows:• Ch. 1–2 Trim Range: 0dB to +60dB• Ch. 3–8 Trim Range: -20dB to +40dB4.2.17.3 – [SHIFT] F UNCTIONALITYThe [SHIFT] button does not perform any special functions when in Trim Mode.4.2.18 – +48VThe [+48V] button is used to adjust K-Mix’s phantom power settings.Similar to the [BYPS] button, the [+48V] button must be held down while performing anyadjustments. |
Related manuals for Keith McMillen Instruments K-MIX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine