K-M IX E DITOR114• When disabled, all audio will be routed out outputs 1–8 as normal.It is important to note that when both surround panning and bass management are enabled, theheadphone output can no longer be used for monitoring input and output channels; it is solelydedicated to the low frequency content.The settable options are as follows:O N /O FF S WITCHThe on/off switch enables or disables K-Mix’s bass management when surround panning is enabled.• ON = Bass management is enabled• OFF = Bass management is disabledC ROSSOVER F REQUENCYSets the center frequency of the crossover.• Audio below the crossover frequency will be routed out the headphone jack.• Audio above the crossover frequency will be routed out outputs 1–8 as normal.• Range: 40Hz – 160Hz5.2.3.4 – S URROUND P ANNERSThe surround panners are used to spatialize/move sounds betweenspeakers in the selected surround sound format.• The blue dots along the edge of the panners represent the speakerplacement of the selected surround format. Each speaker is labelledwith a number representing the K-Mix output channel that speaker’saudio signal will be sent out on.• The four panners mirror the behavior of K-Mix’s four rotary encoderswhen in surround panning mode.• Clicking a surround panner while holding down the COMMAND key will instantly reset the pannerto center.5.2.3.5 – S URROUND P ANNER A SSIGNMENT B UTTONSUsed to assign the input channels to one of the four rotaries.• Once an input channel is assigned, the associated surroundpanner (and rotary on the K-Mix hardware) will be used topan that channel’s audio in the surround field.• It is not possible to have a channel unassigned.These are editor-only parameters. They may not be adjusted from the mixer.1 234CH. 1 CH. 2 CH. 3 CH. 4CH. 5 CH. 6 CH. 7 CH. 8