F EATURES O VERVIEW31Below is a diagram illustrating the signal flow of pre-fader and post-fader sends:A UX P ANNINGEach aux send level is accompanied by an aux panning parameter. The aux panning parameter sets theleft/right panning of the signal going to the selected aux output bus pair.• Audio can be sent out just a single output by panning to the extreme left or right. Full left willgo solely out the odd-numbered output (output 3 for Aux 1, output 5 for Aux 2, output 7 for Aux3); full right will go solely out the even-numbered output (output 4 for Aux 1, output 6 for Aux 2,output 8 for Aux 3).• Centering the pan parameter will send the channel’s audio signal equally to both outputs of theaux pair.Aux panning can be adjusted directly from the K-Mix hardware or the K-Mix Editor.3.5.3 – H EADPHONE O UTPUTK-Mix has a 1/8” stereo headphone output jack at the very front of the hardware. The headphone outputcan be used for a number of purposes.• Monitor any of the four stereo output bus pairs (Mains, Aux 1, Aux 2, Aux 3).• Monitor any of K-Mix’s input channels (pre-fader).• Act as its own discrete stereo output bus, outputs 9–10.• Act as a low frequency crossover output when mixing in surround.Headphone output behavior can be adjusted directly from the K-Mix hardware or the K-Mix Editor.
