Keith McMillen Instruments K-MIX User Manual
Also see for K-MIX: Quick start guide
                                                                                                                                                            | |
Contents
| 
K-M IX H ARDWARE65E XAMPLE U SE1. Press the [EQ] button to go into EQ Mode.2. Select a channel by pressing its channel select button.3. Press and hold the [SHIFT] button.4. While [SHIFT] is still held down, adjust rotary 1, 3, or 4 to alter the Low Frequency, Mid Q, orHigh Frequency parameters.5. Release the [SHIFT] button to go back to normal rotary behavior.4.2.16 – V ERBThe [VERB] button is used to enter K-Mix’s “Reverb Mode” — here you can adjust the reverbsettings for K-Mix’s global reverb send.4.2.16.1 – W HAT D O T HE C ONTROLS D O ?F ADER B EHAVIORIn Reverb Mode, faders 1–8 are used to control the reverb “send level”, the amount of signal beingpassed into the global reverb effect for input channels 1–8. The master fader is used to control theoverall level of the reverb that is mixed in to the main output bus, outputs 1 & 2.• Move a fader up to increase the reverb send level for that channel.• Move a fader down to decrease the reverb send level for that channel.R OTARY B EHAVIORThe four rotaries are used to adjust the global reverb’s settings.• Rotary 1 = PreDelay• Rotary 2 = Damping• Rotary 3 = Diffusion• Rotary 4 = DecayRotaries act like traditional knobs; the minimum value is at 7 o’clock and the maximum value is at 5o’clock.• Move the rotary clockwise to increase the current parameter’s value.• Move the rotary counterclockwise to decrease the current parameter’s value.Since the faders function the same as they do in Mains Mode, [SHIFT] can also beused to solo and mute channels via the faders. |
Related manuals for Keith McMillen Instruments K-MIX
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine