V10/V7.5/V5/V3.5 Installation and Operation Manual Jul.05.07Contents Page3.6.7 View Software Version 3-243.6.8 Select Metered Parameters 3-253.6.9 Set Real Time Clock 3-253.6.10 Front Panel Metering/Setting Display Contrast 3-263.6.11 Calibrate/Configure External Analog Samples 3-263.6.12 Change Hardware Settings 3-273.6.12.1 Calibrate HD PA and IPA Voltages 3-283.6.12.2 Calibrate Front Panel Meter 3-283.6.12.3 Calibrate Meters 3-283.6.12.4 Enable/Disable Setup Mode 3-293.6.12.5 Set PA Bias Levels 3-293.6.12.6 Set Protection Threshold Levels 3-293.6.12.7 System Configuration 3-303.6.12.8 Save/Recall Factory Settings 3-303.6.13 Set Main/Standby Operation 3-314 TESTING AND ADJUSTMENT4.1 INTRODUCTION 4-14.2 OPERATING PRECAUTIONS 4-14.3 FUNCTIONAL TESTS 4-14.3.1 General 4-14.3.2 Test Equipment Required 4-24.3.3 Test Prerequisites 4-24.3.4 Transmitter Turn-On 4-44.3.5 Remote Control Checks 4-44.3.5.1 Remote Control Prerequisites 4-44.3.5.2 Remote On/Off Control 4-54.3.5.3 Remote Selection of Active Exciter 4-54.3.5.4 Remote Selection of Active IPA Module or PA 4-64.3.5.5 Remote Selection of Active IPA Power Supply 4-64.3.5.6 Remote Selection of Fan Power Supply 4-74.3.5.7 Remote Power Level Controls 4-74.3.5.8 Remote Power Trim Control 4-84.3.5.9 Remote Reset Control 4-94.3.6 Protection Circuit Checks 4-94.3.6.1 External Interlock 4-94.3.6.2 Exciter Auto Changeover Check 4-104.3.6.3 IPA Auto Changeover Check 4-114.3.6.4 IPA PS Auto Changeover Check 4-124.3.6.5 Fan Supply Changeover Check 4-124.3.7 Improving Reject Load Power 4-134.4 NON-STANDARD ADJUSTMENT 4-144.4.1 Changing Frequency 4-144.4.2 Changing Ac Input Configuration 4-14
