10.1 Overview of High-speed Counter Function10-310.1.3 Areas Used For High-speed Counter FunctionThe usable combinations vary according to the unit type. List of used areasFP0H modeChannel no.Input no.Control flag Elapsed valuearea Target value areaSingle-phase2-phaseCH0 X0 X0, X1 R9110 DT90300DT90301DT90302DT90303CH1 X1 - R9111 DT90302DT90303DT90306DT90307CH2 X3 X3, X4 R9112 DT90308DT90309DT90310DT90311CH3 X4 - R9113 DT90312DT90313DT90314DT90315FPΣ modeChannel no.Input no.Control flag Elapsed valuearea Target value areaSingle-phase2-phaseCH0 X0 X0, X1 R903A DT90044DT90045DT90046DT90047CH1 X1 - R903B DT90048DT90049DT90050DT90051CH2 X3 X3, X4 R903C DT90200DT90201DT90202DT90203CH3 X4 - R903D DT90204DT90205DT90206DT90207(Note 1): Functions, channel numbers and I/O numbers used are set in the tool software.(Note 2): I/O numbers used for each function should be allocated so that they do not overlap. Refer to"1.2Restrictions on Combinations and Functions".REFERENCE• For details of the FPΣ mode, refer to "11. FPΣ Mode".
