9.17 PBX Configuration—[1-1]Configuration—Slot—V-IPCS—Card PropertyThe properties of the V-IPCS card can be specified.Signalling (PTAP) UDP Port No. (Server)Specifies the UDP port used by the V-IPCS card to transmit and receive PTAP (Panasonic TelephonyAdministration Protocol) data. This must be changed if another network application is using the same port.To change the value displayed here, click Common Settings and set the desired value.Value Range1024–65535Maintenance Console Location9.17 PBX Configuration—[1-1] Configuration—Slot—V-IPCS—Card PropertySignalling (MGCP) UDP Port No. (Server)Specifies the UDP port used by the V-IPCS card to transmit and receive MGCP (Media Gateway ControlProtocol) data. This must be changed if another network application is using the same port.To change the value displayed here, click Common Settings and set the desired value.Value Range1024–65535Maintenance Console Location9.17 PBX Configuration—[1-1] Configuration—Slot—V-IPCS—Card PropertySignalling (MGCP) UDP Port No. (IP-CS)Indicates the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on theIP-CS side (reference only).Value Range2427Maintenance Console Location9.17 PBX Configuration—[1-1] Configuration—Slot—V-IPCS—Card PropertyVoice (RTP) UDP Port No. (IP-CS)Specifies the UDP port used to transmit and receive RTP (Real-time Transfer Protocol) data on the IP-CS side.This must be changed if another network application is using the same port.For voice communications, an IP-CS uses 128 contiguous UDP ports, starting from the port number specifiedhere.To change the value displayed here, click Common Settings and set the desired value.326 PC Programming Manual9.17 PBX Configuration—[1-1] Configuration—Slot—V-IPCS—Card Property