23.3.2 UM Configuration—[4-3] Service Settings—CustomService—Date ControlThe below parameters are set for the Date Control Custom Service in the Custom Service Builder.This service allows you to assign a different operation for up to 5 time periods. The caller makes no selectionand no menu is announced.DescriptionThe information typed in this field is for reference only.Value RangeMax. 32 charactersMaintenance Console Location23.3.2 UM Configuration—[4-3] Service Settings—Custom Service—Date ControlFeature Guide References3.2.1.15 Custom ServicePeriod 1–5, OutsidePeriod 1–5:Specifies the name of date period for reference, start and end date, and an operation.Outside:Allows you to specify an operation that is enabled on all other dates not included in the set periods.Value RangePeriod 1–5:Name: Max. 16 charactersFrom/To: Select the check box, and then click the input field to select a date (month and day) from the calendar.You can specify a beginning date (From), ending date (To), or both for each period.Assigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, None (see23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer— Key –Assigned Operation: 0–9, *, #)Outside:Name: Max. 16 charactersAssigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, None (see23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer— Key –Assigned Operation: 0–9, *, #)Maintenance Console Location23.3.2 UM Configuration—[4-3] Service Settings—Custom Service—Date Control928 PC Programming Manual23.3.2 UM Configuration—[4-3] Service Settings—Custom Service—Date Control