18.2 PBX Configuration—[10-2] CO & IncomingCall—DIL Table & Port SettingsDirect In Line (DIL) or Direct Dialling In (DDI)/Direct Inward Dialling (DID) can be selected for each trunk asthe method of distributing incoming trunk calls to certain destinations. For each trunk to which DIL distributionis set, different destinations can be programmed depending on the time mode (day/lunch/break/night). Ifdesired, Calling Line Identification (CLI) distribution can be used in conjunction with DIL distribution.DILFor each trunk to which DIL distribution is set, different DIL destinations can be programmed depending onthe time mode (day/lunch/break/night). Generally, DIL distribution is used for trunk calls from analogue trunks.Tenant number and service group number can also be programmed for each trunk.To assign DIL destination numbers, enter directly or click Destination Setting (see 2.1.6 Extension NumberSetting).The Shelf, Slot, and Port for each item are displayed for your reference. For details, see CommonProgramming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.Card TypeIndicates the trunk card type (reference only).Value RangeCard typeMaintenance Console Location18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port SettingsFeature Guide References2.1.1.1 Incoming Trunk Call Features—SUMMARYTrunk PropertyIndicates the networking type of each trunk (reference only).Value RangePublic, Private(TIE), VPNMaintenance Console Location18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port SettingsFeature Guide References2.1.1.1 Incoming Trunk Call Features—SUMMARY4.2.1 TIE Line Service4.2.3 ISDN Virtual Private Network (ISDN-VPN)PC Programming Manual 81318.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings