9.22 PBX Configuration—[1-1]Configuration—Slot—Extension—Port PropertyVarious settings can be programmed for each extension port.To view the total number of each type of extension connected, click Port Type View.The Shelf, Slot, and Port for each item are displayed for your reference. For details, see CommonProgramming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.NoteOther programming items that are displayed on this screen but not listed below are used only whenprogramming extensions connected to a Expansion Unit.For information about Expansion Units, see 9.32 PBX Configuration—[1-1]Configuration—Slot—Expansion Unit1/Expansion Unit2/Expansion Unit3.Port TypeIndicates the port type (reference only).Value RangeSLT/DPT/S-Hybrid/S-Hybrid (S-DPT)/S-Hybrid (SLT)/IP-EXT/SIP-MLT/SIP/ISDN/UMMaintenance Console Location9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port PropertyTelephone TypeIndicates the connected telephone type (reference only).Value RangeAPT/DPT/DSS/VM/ISDN-Extension/IP-PT/UT/SIP/SIP-CS/S-PS/CS/CS-M/CS-S1/CS-S2/CS-S3/NoConnection/UNKNOWNMaintenance Console Location9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port PropertyConnectionIndicates the port status. To change the status of the port, click the desired cell in the column, and then selectINS or OUS for the port.This option is only available in On-line mode.Value RangeINS: The port is in service.OUS: The port is out of service.Fault: The port is not communicating with the PBX.Maintenance Console Location9.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port PropertyPC Programming Manual 3539.22 PBX Configuration—[1-1] Configuration—Slot—Extension—Port Property