Panasonic PT-VW360 Operating Instructions Manual

Also see for PT-VW360: Operating instructions Operating instructions

Contents

Indicator status StatusOff The power plug is not connected to the outlet.RedLit The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →[STANDBY MODE] is set to [ECO].Blinking*1 The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →[STANDBY MODE] is set to [NETWORK].Blinking*2 The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →[STANDBY MODE] is set to [NORMAL].GreenLit Projecting.Blinking*3 The luminous lamp is turned off. The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWERMANAGEMENT] is set to [READY].Blinking*4 The projector is preparing to project. The projector will project image after a while.Orange Lit The projector is preparing to be switched off.The power is switched off after a while. (Changes to the standby mode.)*1 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off)*2 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off)*3 The indicator flashes in the cycle: 2.0 seconds (light) → 2.0 seconds (off)*4 The indicator flashes in the cycle: 0.5 seconds (light) → 0.5 seconds (off)Notef While the power indicator lights in orange, the fan is running to cool the projector.f For about 90 seconds after the projector is switched off, the luminous lamp does not light up even if the power is switched on. Turn on thepower again after the power indicator lights/blinks in red.f The projector consumes power even in standby mode (power indicator lights/blinks in red). Refer to “Powerconsumption” (x page 130) for the power consumption.Powering on the projectorBefore switching on the projector, make sure the projector and the external devices are correctly connected(x page 34) and the lens cap is removed beforehand.AUTO SETUP3)3)2)1)1) Connect the power cord to the projector body.2) Connect the power plug to an outlet.f The power indicator lights or blinks, and the projector will enter the standby mode.3) Press the power <v/b> button.f The power indicator lights in green and the image is soon projected on the screen.Attentionf Be sure to remove the lens cap before starting projection.Notef If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longerbefore the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.ENGLISH - 39Chapter 3 Basic Operations - Powering on/off