[PROJECTOR ID]The projector has an ID number setting function that can be used when multiple projectors are used side by sideto enable simultaneous control or individual control via a single remote control.1) Press as to select [PROJECTOR ID].2) Press the button.f The [PROJECTOR ID] screen is displayed.3) Press as to select a projector ID.f Select one from [ALL], and [1] to [6].[ALL] Select when controlling projectors without specifying an ID number.[1] - [6] Select when specifying an ID number to control individual projector.4) Press the button to set it.f [PROJECTOR ID] is set.Notef To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computercontrol.If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors with other IDnumbers.f Refer to “Setting the ID number of the remote control” (x page 49) for how to set the ID number on the remote control.[INITIAL START UP]Set the startup method when the projector is switched on after connecting the power plug to outlet.1) Press as to select [INITIAL START UP].2) Press qw to switch the item.f The items will switch each time you press the button.[LAST MEMORY] Starts up in the status that before removing the power plug from the outlet or turning off the circuit breaker.[STANDBY] Starts up in the standby mode.[ON] Starts the projection immediately.[PROJECTION METHOD]Set the projection method in accordance with the installation status of the projector.Change the projection method if the screen display is upside down or inverted.1) Press as to select [PROJECTION METHOD].2) Press qw to switch the projection method.f The items will switch each time you press the button.[AUTO] Detects the projector’s posture with built-in angle sensor, then switches to [FRONT/DESK] or [FRONT/CEILING].Usually it is set to [AUTO] when projecting in front of the screen.[FRONT/DESK] Select when installing the projector on the desk, etc., in front of the screen.[FRONT/CEILING] Select when installing the projector in front of the screen with the Ceiling Mount Bracket (optional).[REAR/DESK] Select when installing the projector on the desk, etc. behind the screen (with a translucent screen).[REAR/CEILING] Select when installing the projector behind the screen (with a translucent screen) with the Ceiling MountBracket (optional).Notef When set to [AUTO], front projection or rear projection cannot be detected. When projecting from rear, please set the [PROJECTIONMETHOD] to [REAR/DESK] or [REAR/CEILING].f Refer to “Angle sensor” (x page 30) for details on the range of the installation attitude that can be detected by the built-in angle sensor.[HIGH ALTITUDE MODE]Change the setting according to the altitude in which you use the projector.ENGLISH - 75Chapter 4 Settings - [PROJECTOR SETUP] menu
