[PROJECTOR SETUP] menuOn the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-menu.Refer to “Navigating through the menu” (x page 52) for the operation of the menu screen.[STATUS]You can check the using status of the projector.1) Press as to select [STATUS].2) Press the button.f The [STATUS] screen is displayed.[SIGNAL] [NAME] Displays the name of input signal.[FREQUENCY] Displays the scanning frequency of input signal.[RUNTIME][PROJECTOR] Displays the actual usage time of projector.[LAMP(ET-LAV300)]Displays the model No. of the replacement lamp unit for this projector.[ECO] Displays the luminous lamp runtime in actual time when [LAMPPOWER] is set to [ECO].[NORMAL] Displays the luminous lamp runtime in actual time when [LAMPPOWER] is set to [NORMAL].[TOTAL]*1Displays the total runtime converted from the runtime at [ECO]and [NORMAL]. Please use it to predict when to replace the lampunit.[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.*1 The total runtime displayed is calculated automatically using the following conversion formula.Formula for lamp unit replacement time (rough estimate)A × 1 + B × 5/7f A : The luminous lamp runtime when [LAMP POWER] is set to [NORMAL]f B : The luminous lamp runtime when [LAMP POWER] is set to [ECO]Notef If you attach a lamp unit used in a projector of a model different from the projector (PT-VW360, PT-VX430) to the projector, or when thelamp unit used in the projector to a projector of a different model, the [RUNTIME] displayed in [STATUS] may differ from the actual time.f For the network status, refer to the [NETWORK/USB] menu → [STATUS]. (x page 88)f The model number of the optional replacement lamp unit is subject to change without prior notice.[COMPUTER1 INPUT SETTING]Switch the input setting of the terminal.1) Press as to select [COMPUTER1 INPUT SETTING].2) Press qw to switch the item.f The items will switch each time you press the button.[RGB/YPBPR] Select when inputting the RGB signals or YPBPR(YCBCR) signals to the terminal.[Y/C] Select when inputting the Y/C signals to the terminal by using the D-SUB - S Videoconversion cable (model number: ET-ADSV).[COMPUTER2 SELECT]Switch the input/output of the terminal.1) Press as to select [COMPUTER2 SELECT].2) Press qw to switch the item.f The items will switch each time you press the button.[COMPUTER2 IN] Select when inputting the RGB signals or YPBPR(YCBCR) signals to the terminal.[COMPUTER1 OUT] Select when the RGB signals or YPBPR(YCBCR) signals input to the terminal is outputfrom the terminal.Notef When COMPUTER2 input is selected, [COMPUTER2 SELECT] cannot be set.74 - ENGLISHChapter 4 Settings - [PROJECTOR SETUP] menu
