When the initial setting screen is displayedWhen the projector is switched on for the first time after purchase as well as when [INITIALIZE ALL] in the[PROJECTOR SETUP] menu is executed, then the initial setting screen is displayed. Set them in accordance withcircumstances.In other occasions, you can change the settings by menu operations.If you press the [INITIAL SETTING] screen is displayed, you can go back to theprevious screen.Same operation is available by pressing the button.Notef When the projector is used for the first time, in order to clearly display the menu screen, it may be necessary to adjust the focus ringand the zoom ring in the projection lens area of the projector (x page 24). For details, refer to “How to adjust the state of the image”(x page 44).Initial setting (display language)Select the language to show on the screen.After completed the initial setting, you can change the display language from the [LANGUAGE] menu.1) Press asqw to select the display language.2) Press the button to proceed to the initial setting.Initial setting (installation setting)If necessary, change the setting of each item.INITIAL SETTINGPROJECTION METHODSCREEN FORMATIf STANDBY MODE is set to ECO,you cannot use network functionswhen the projector is standing by.Also, you cannot use some RS-232Cprotocol commands.STANDBY MODESCREEN POSITIONAUTONORMAL1610ENTERSELECTRETURNINITIAL SETTINGPROJECTION METHODSCREEN FORMATIf STANDBY MODE is set to ECO,you cannot use network functionswhen the projector is standing by.Also, you cannot use some RS-232Cprotocol commands.STANDBY MODESCREEN POSITIONAUTONORMAL43ENTERSELECTRETURNPT-VW360 PT-VX4301) Press as to select an item.40 - ENGLISHChapter 3 Basic Operations - Powering on/off