Adjusting the volume1) Press as to select [AUDIO SETTING].2) Press the button.f The [AUDIO SETTING] screen is displayed.3) Press as to select [VOLUME].4) Press qw to adjust the level.Operation Adjustment RangePress the w button. Increases the volume. 0 ~ 63Press the q button. Decreases the volume.Adjusting the balance1) Press as to select [AUDIO SETTING].2) Press the button.f The [AUDIO SETTING] screen is displayed.3) Press as to select [BALANCE].4) Press qw to adjust the level.Operation Adjustment RangePress the w button. Increase the volume of the right channel. L16 ~ R16Press the q button. Increase the volume of the left channel.Setting the mute status1) Press as to select [AUDIO SETTING].2) Press the button.f The [AUDIO SETTING] screen is displayed.3) Press as to select [MUTE].4) Press qw to switch the item.[OFF] Outputs the audio.[ON] Turns off the volume temporarily.Setting the audio output during standby1) Press as to select [AUDIO SETTING].2) Press the button.f The [AUDIO SETTING] screen is displayed.3) Press as to select [IN STANDBY MODE].4) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Disables audio output in the standby mode.[ON] Enables audio output in the standby mode. At this time, press the button / button on theremote control or qw buttons on the control panel to adjust the volume.Notef When [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or [NETWORK] (x page 77), even if [IN STANDBY MODE] is set to[ON], audio cannot be output during standby.f When the power is switched off at the digital signal input with [IN STANDBY MODE] set to [ON], the audio may be interrupted in the processof the projector entering the standby mode.Setting audio input selectionChoose the audio input terminal for each input signal.ENGLISH - 79Chapter 4 Settings - [PROJECTOR SETUP] menu