Panasonic PT-VW360 Operating Instructions Manual

Also see for PT-VW360: Operating instructions Operating instructions

Contents

[NETWORK/USB] menuOn the menu screen, select [NETWORK/USB] from the main menu, and select an item from the sub-menu.Refer to “Navigating through the menu” (x page 52) for the operation of the menu screen.Notef The on-screen menu (menu screen) of the projector has not the network setting about the wireless LAN. When the wireless module (ModelNo.: ET-WML100) of the optional accessories is inserted to the projector, please set the wireless LAN by accessing the projector via acomputer. For detailed, please refer to “Web control function” → “[Network config] page” → “Wireless LAN” (x page 105).[WIRED LAN]Perform the connection settings to use wired LAN.1) Press as to select [WIRED LAN].2) Press the button.f The [WIRED DETAILED SETUP] screen is displayed.3) Press as to select an item, and change the setting according to the instructions.[DHCP][OFF] Set when a DHCP server does not exist in the network to which the projector isconnected and you need to specify the IP address.[ON] Set when a DHCP server exists in the network to which the projector isconnected and the IP address is obtained automatically.[IP ADDRESS] Enter the IP address when [DHCP] is set to [OFF].[SUBNET MASK] Enter the subnet mask when [DHCP] is set to [OFF].[DEFAULT GATEWAY] Enter the default gateway address when [DHCP] is set to [OFF].[DNS1] Enter the preferred DNS server address when [DHCP] is set to [OFF].[DNS2] Enter the alternate DNS server address when [DHCP] is set to [OFF].4) Press as to select [OK], and press the button.r Default wired LAN settingsf The following settings are set before the projector leaves the factory.[DHCP] OFF[IP ADDRESS] 192.168.10.100[SUBNET MASK] 255.255.255.0[DEFAULT GATEWAY] 192.168.10.1[DNS1]/[DNS2] NONENotef When using a DHCP server, confirm that the DHCP server is running.f For the setting content of each item, consult your network administrator.f A wired LAN and wireless LAN cannot be used in the same segment.[NAME CHANGE]Change the name as desired in such a case as the projector needs to be identified on application software.1) Press as to select [NAME CHANGE].2) Press the button.f The [NAME CHANGE] screen is displayed.3) Select characters with the asqw buttons and press the button to enter the projectorname.f Up to eight characters can be input.f Select [ALL DELETE] to delete all the entered characters, or press the button on the remotecontrol to delete a character on the cursor in the entry field.ENGLISH - 85Chapter 4 Settings - [NETWORK/USB] menu