Installation2-53160-A2-GB22-10 December 1996Box ContentsThe 3160/3164 DSU/CSU product arrives in a singlebox and should contain the following:• One 3160/3164 DSU/CSU standalone unit• One 14.5 foot VF cable• One power transformer• One ACCULINK 3160/3164 DSU/CSU ReferenceCard• One ACCULINK 316x Data Service Unit/ChannelService Unit Operator ’s GuidePlease refer all servicing to qualified personnel. TheDownload front panel branch is dedicated to DSU/CSUservice and maintenance and is not intended for use by thecustomer.The 3100 Series Front Panel Emulation software isavailable separately and is described in the Front PanelEmulation Software Installation section later in thischapter.Important Safety InstructionsRead and follow all warning notices and instructionsmarked on the 316x DSU/CSU or included in this guide.NOTEThe Download command is foruse by service personnel only.Loss of primary data could resultfrom improper use.HANDLING PRECAUTIONSFORSTATIC-SENSITIVE DEVICESThis product is designed to protectsensitive components from damagedue to electrostatic discharge (ESD)during normal operation. Whenperforming installation procedures,however, take proper static controlprecautions to prevent damage toequipment. If you are not sure of theproper static control precautions,contact your nearest sales or servicerepresentative.For a complete listing of the safety instructions, see theImportant Safety Instructions section earlier in this guide.Quick Start ProcedureThe following procedure is for experienced DSU/CSUusers who are familiar with the 3160/3164 DSU/CSUinstallation process and have no special requirements fortheir application.1. Attach the power cord to the rear of the DSU/CSUand the other end to a grounded 115 Vac poweroutlet.2. Attach the 3160/3164 DSU/CSU networkconnection to the T1 network using theappropriate cable. Attach the 3160/3164DSU/CSU to the CPE via the DTE (DSX-1)and/or ports connectors. Adapter cables areavailable which allow RS449 or V.35 devices tobe supported from the EIA 530A connector on therear panel. Refer to Appendix H, Equipment List.See the 3160/3164 DSU/CSU Cabling section laterin this chapter for more cabling information.3. Power on the DSU/CSU to perform the power-upself-test. See the Power-Up Self-Test section laterin this chapter for more information.4. To perform front panel emulation, connect thecable from the PC to the COM port on the rearpanel of the DSU/CSU. To perform devicemanagement from an async terminal, connect theterminal to the COM port (or for dial-in access,the modem port) on the rear panel of theDSU/CSU. See the 3160/3164 DSU/CSU Cablingsection later in this chapter for more cablinginformation.
