ACCULINK 316x DSU/CSU2-10 December 1996 3160-A2-GB22-10Differences Using the Async Terminal: To monitor theself-test from the async terminal, select Health, TestStatus, and Self Test Results from the main/status menu.The full screen display capacity provides a complete testresults screen that includes the self-test results.Figure 2-10 shows an example of this screen.Customer ID: New Custmain/status/health_and_statusModel: ACCULINK XXXXHealth and StatusDSU OperationalLOS at NetLOS at DTEOOF at NetOOF at DTEAIS at NetAIS at DTEEER at NetYellow at NetYellow at DTEMaster Clock FailSNMP Link DownSelftest failedDevFail yyyyyyyyDownload failedAlm Retry DisabTest in progressModem ConnectedSelf Test ResultsCPU failDevice failB8ZS/LOS failModem failDTE T1 failAlarm failLCD failNET T1 failMemory failDSU failDSU Port 1 failDSU Port 2 failDSU Port 3 failDSU Port 4 failUnknown Exp DevFailure xxxxxxxxPassedTest StatusNo Test ActiveLLB Test ActivePLB Test ActiveDLB Test ActiveRLB Test ActiveDCLB on Port nDTLB on Port nQRSS Test Active1–8 Test ActiveQRSS on Port n511 on Port nMonitoring QRSSMonitoring QRSS, Port nMonitoring 511, Port nDLB Test, ExtrnLamp Test ActiveRefresh Down UP Main Previous Cntrl–x to DisconnectFigure 2-10. Health and Status Results ScreenIf a test fails, fail appears next to the componentreporting the failure.To perform a power or reset of the device, seeResetting the CSU/DSU in Chapter 4.Selecting a Model 3161DSU/CSUUse the SDCP when accessing a specific circuit cardinstalled in the 3000 Series Carrier.To access a 3161 DSU/CSU,1. Press Select on the SDCP.2. Enter a valid carrier and slot address. The greenOK indicator on the selected 3161 DSU/CSUshould flash. (It should be the only OK indicatorflashing in the cabinet.)3. Press Select again. The display on the SDCPshould show the last menu item displayed, or inthe case of a new installation, the top-level menuon the selected circuit card.DSU/CSU IdentityThe identity of the 316x DSU/CSU (serial number,model number, software revision level, hardware revisionlevel, and customer ID) is available through the Statusbranch of the front panel menu (see Appendix A, FrontPanel Menu).The customer ID is the only identity number you canchange.To display the DSU/CSU’s identity,1. Press F1 to select Status from the top-level menuscreen.F1DS U E SFStat Test CnfigF2 F32. Press the key three times on the Status screento bring the ID selection onto the front panel LCD.F1Status:DevHS STest PerfF2 F33. Press F3 to select ID from the Status screen.F1Status:TStat LED IDF2 F3
