Samsung OfficeServ 7100 Technical Manual

Also see for OFFICESERV 7100: Quick guide System administration guide User guide User manual User guide

Contents

OfficeServ 7100 PROGRAMMINGTECHNICAL MANUAL PART 2 MAY 2009MMC: 831 MGI PARAMETERSDESCRIPTION:This MMC only applies to MGI-16 cards installed in the system.NOTE: If you only have the MP10/MP10a on-board MGI ports this becomes“READ ONLY” MMC since it has the same values as the MP10/MP10a.This MMC provides the means to configure the Internet Protocol (IP) addressing ofthe OfficeServ 7100 system MGI resources and hardware. This MMC must beutilized if there are ITP series phone(s) and/or MGI card(s) used on the system (or ifthe on-board MGI ports are enabled via licenses).NOTE: This MMC cannot be accessed unless there is an MGI-16 card installed inthe system or has MGI licenses enabled for the built-in MGI ports on theMP10/MP10a.¾ NOTE: When changing any IP address/value, listed below, three digits mustbe input for each (octet) field. Example 192.168.1.10 input must be: 192 168001 010¾ PLEASE ALSO NOTE: The first 3 parameters: IP ADDRESS, GATEWAY, andSUB MASK - changes to these parameters will not be applied until the MGIis reset, use the reset option below to reset the MGI.• IP ADDRESS: Specifies the IP address for the MGI card. The MGI ports built-into the MP10/MP10a will have the same IP address as the MP10/MP10a.• GATEWAY: Specifies the designated LAN gateway IP address used forcontacting IP devices beyond the local subnet.• SUB MASK: Specifies the IP subnet mask. This parameter is used by thesystem to calculate the range if IP devices (subnet) that are within “direct reach”of the MGI (without having to go through the designated network IP gateway).• IP TYPE: Defines which IP addressing relationship is used for communicationsto and from the MGI card.• PRIVATE IP ONLY – the system assumes all ITP/VOIP devices are on thesame network. Traffic involving non-IP based devices (such as analog trunks,digital keysets, voicemail, etc.) are handled VIA the MGI card.