Ubigate iBG2016 Configuration Guide/Ed.00© SAMSUNG Electronics Co., Ltd. 165R1-RSVP-TERouter#configure terminalRouter/configure# rsvp-path mypathRouter/configure/rsvp-path# hop-address 10.10.23.60Router/configure/rsvp-path# hop-address 10.10.21.90Router/configure/rsvp-path# exitRouter/configure# rsvp-trunk T1Router/configure/rsvp-trunk# primary no-cspfRouter/configure/rsvp-trunk# primary path mypathRouter/configure/rsvp-trunk# primary bandwidth 10mRouter/configure/rsvp-trunk# to 192.168.2.90Router/configure/rsvp-trunk#Adding a Secondary LSP to the TrunkAlthough the attributes of a Secondary Label Switched Path(LSP) areindependent of the Primary LSP, a Secondary LSP cannot be configuredwithout first configuring a Primary LSP. Besides information on how toconfigure a secondary LSP, this example illustrates how to define non-defaultsetup and hold priority for an LSP. Setup and hold priorities are used todetermine which LSP should be given a preference when competing forresources. Specifically the setup priority of an unestablished LSP is comparedto the hold priorities of existing established LSPs and the numerically lowerone is given a preference. However, once the LSP gets established, its setuppriority is never used until it gets pre-empted or reset and is being brought upagain.Figure 9.9 Adding Secondary LSPlo192.168.0.63 eth 2/1192.168.0.60192.168.0.90eth 0/0R1R2 eth 1/110.10.23.0/24 10.10.21.0/24eth 0/1loloeth 2/1 eth 1/1R3
