Ubigate iBG2016 Configuration Guide/Ed.00© SAMSUNG Electronics Co., Ltd. 213L2 Bridge Based CoS MarkingThe first stage that assigns CoS attributes is the Bridge processing stage.To configure the bridge port TC assignment, enter:Router/configure/interface/ethernet (3/0)/qos# [no]override-outq Using the no form will switch off TC override. When TC override is ‘off’, theTC gets reassigned based on the UP of the packet in the next stage.UP-based TC assignment uses the UP attribute of the packet(if tagged) toassign the TC attribute.To configure the associated table, enter:Router/configure/qos# [no] map-up-to-outq []Using the no form will reset a specific row to default UP-based DPassignment uses the UP attribute of the packet to assign the DP attribute.The associated table can be configured using the following commandRouter/configure/qos# [no] map-up-to-dp []Using the no form will reset a specific row to default TC-based UPassignment uses the TC attribute of the packet to assign the UP attribute, if thepacket is untagged.To configure the associated table, enter:Router/configure/qos# [no] map-outq-to-up []Using the no form will reset a specific row to default.
