CHAPTER 8. Routing and Digit Manipulation592 © SAMSUNG Electronics Co., Ltd.Dial Plan ModeDial Plan ModeDial plan mode is a mode that set global configuration for dial-planThe Following are commands of dial-plan mode.Command Purposecp-toneExample)sbm/configure/dial-plan # cp-tone krThe cp-tone command is to set the voice interfaceof tone(ring, busy, cadence) for a specific country.fxs-pattern tag full-fxs-patternext-leng ext-patternExample)sbm/configure/dial-plan # fxs-pattern 1 802343849.. 4 49..To create a global prefix that can be used toexpand the extension numbers of inbound andoutbound calls into fully qualified E.164 numbers intoll by pass mode, use the fxs-pattern command.The maximum number that could be configured is5. Digit and dot(.) could be entered.max-call numExample)sbm/configure/dial-plan #max-call 512To set the maximum number of calls that a systemcan handle, use the max-call command in dial planconfiguration mode. Default value is unlimited.Range is from 1 to 10000.secondary-dialtone stringExample)sbm/configure/dial-plan/secondary-dialtone #secondary-dialtone 9To enable a secondary dial tone, use thesecondary-dialtone command. The maximumnumber that could be configured is 10.
