Ver.CHAPTER 4. AP Connection Management© SAMSUNG Electronics Co., Ltd. page 134 of 4962600-00FK1RGA4 3.0Parameter DescriptionPORT CAPWAP PORT number of the APC to addThis port number is required by an AP to connect to the APC. If no portnumber is entered, it is set to 5246, the default port number of CAPWAPprotocol. It is recommended not to use a different port number if it isspecially required.FALLBACK START-END TIMEEnter the time zone where an AP connected to the backup (secondary ortertiary) APC can do fallback.The input format is as follows:- Format: hh:mm-hh:mm- Example: 2:00-5:00 Fallback is available between 2pm and 5pm.INTERVAL Configures the interval that an AP connected to the backup (secondary ortertiary) APC attempts fallback (second).If a specific time is not entered, the default is 120 seconds.The minimum is 60 seconds and the maximum is 1800 seconds.3) Enter into the configure AP configuration mode of CLI and configure a primary,secondary, and tertiary server. To make an AP operate in redundancy configuration,configure the Discovery of the AP as ‘apc-referal’.WEC8500# configure terminalWEC8500/configure# ap ap_1WEC8500/configure/ap ap_1# discovery apc-referal primary-apc [APC_NAME] secondary-apc [APC_NAME] tertiary-apc [APC_NAME]Parameter DescriptionAPC_NAME Enter the name of an APC registered to redundancy.- Primary apc: The first APC that the AP attempts to connect.It is usually configured with the currently connected APC.- Secondary-apc, tertiary-apc: APC that the AP attempts to connect whenthere is no response from the primary-apc.DISCOVERY_TYPE Discovery Type- ap-followed: Discovery type is set by AP.- apc-referal: Discovery type is set by APC using the backup APC lists.To apply the priority of APC to which the AP will be connected, operatorneeds to select the apc-referal.- multicast: Multicast discovery type- broadcast: broadcast discovery type- DHCP: Discovery type is interoperating with the DHCP server. To use thismode, IP ADDRESS POLICY of the AP must be set to DHCP.
