Ver.CHAPTER 3. Data Network Function© SAMSUNG Electronics Co., Ltd. page 44 of 4962600-00FK1RGA4 3.0The port related CLI commands are as follows:[auto-nego, speed, duplex]The commands used to configure an auto-nego, speed, and duplex addresses are shownbelow. To delete the configuration, enter the ‘no’ parameter.WEC8500/configure/interface ge1# speed-duplex ?10-full Set 10Mb/s full-duplex10-half Set 10Mb/s half-duplex100-full Set 100Mb/s full-duplex100-half Set 100Mb/s half-duplex1000-full Set 1000Mb/s full-duplex1000-half Set 1000Mb/s half-duplexauto-nego Set auto negotiation speed/duplex[admin status]This is a command that makes the port not working. The ‘no’ parameter is used to restartthe port.shutduownno shutdown[flow control]This is a command that operates flow control to the port. The ‘no’ parameter is used to stopthe flow control.flowcontrol onno flowcontrol on[switch port]This is a command that changes the port to the L2 mode. The ‘no’ parameter is used tochange it to the L3 mode.switchportno switchport[ip address]This is a command that configures a static IP address. To delete the configuration, enter the‘no’ parameter. ip address {A.B.C.D/mask length} no ip address {A.B.C.D} {A.B.C.D} no ip address {A.B.C.D/mask length}
