Ver.CHAPTER 6. Wi-Fi Configuration© SAMSUNG Electronics Co., Ltd. page 223 of 4962600-00FK1RGA4 3.06.4 Country CodeYou can use a country code to restrict the number of channels that can be used in an AP andthe maximum transmission power of each channel.Configuration using CLITo configure the country code function, go to country mode first by executing thefollowing command.APC# configure terminalAPC/configure# countryAPC/configure/country#[Global Country Code Configuration]If you configure a global country code, the country code can be specified to all theconnected APs at the same time. The command is shown below. set-global [COUNTRY_CODE] [VALUE]Parameter DescriptionCOUNTRY_CODE Country code to configureVALUE Environment configuration (both/outdoor/indoor/none)To check the configuration information, use the ‘show country global-config’ command.[AP Country Code Configuration]To configure a country code, execute the command as follows: set-ap [AP_ID] [COUNTRY_CODE] [VALUE]Parameter DescriptionAP_ID AP ID (range: 1-500)COUNTRY_CODE Country code to configureVALUE Environment configuration (both/outdoor/indoor/none)To check the configuration information, use the ‘show country ap-config [AP_ID]’command.
