Ver.CHAPTER 7. WLAN Additional Services© SAMSUNG Electronics Co., Ltd. page 250 of 4962600-00FK1RGA4 3.0[Enable/Disable Spectrum]The command that enables or disables the spectrum analysis function is shown below. service [MODE]Parameter DescriptionMODE Enables or disables spectrum analysis- enable: Enable (default)- disable: Disable[Spectrum Analysis Report Configuration]The command used to enable or disable each spectrum analysis data item is shown below. configuration-request [DATA] [MODE]Parameter DescriptionDATA Type of a report to configure (sample/duty-cycle/interference)- sample: FFT report (default: disabled)- duty-cycle: Duty cycle report (default: disabled)- interference: Interference report (default: enable)MODE Enables or disables each report function.- enable: Enable- disable: Disable[Channel Report Interval Configuration]The command is shown below. channel-interval [INTERVAL]Parameter DescriptionINTERVAL Channel report interval (range: 1000-60000 ms, default: 1000)[Changing Channel]By using the following command, you can change a channel for which the spectrumanalysis will be executed.(The default is ‘All’ channels.) dot11b: 2.4 GHz wireless bandwidth dot11aLow: 5 GHz low wireless bandwidth dot11aMid: 5 GHz mid wireless bandwidth dot11aHigh: 5 GHz high wireless bandwidth
