Ver.CHAPTER 3. Data Network Function© SAMSUNG Electronics Co., Ltd. page 75 of 4962600-00FK1RGA4 3.03.4.5.5 Network ConfigurationConfiguration using CLI1) Go to configure ospf configuration mode of CLI.WEC8500/configure/router/ospf 2# ?area OSPF area parametersauto-cost Calculate OSPF interface cost accordingto bandwidthcapability Enable specific OSPF featurecompatible OSPF compatibility listdefault-information Control distribution of defaultinformationdefault-metric Set metric of redistributed routesdistance Define an administrative distancedistribute-list Filter networks in routing updatesexit Exit from router modehost OSPF stub host entrymax-concurrent-dd Maximum number allowed to process DDconcurrentlymaximum-area Maximum number of ospf areaneighbor Specify a neighbor routernetwork Enable routing on an IP networkospf OSPF specific commandsoverflow Control overflowpassive-interface Suppress routing updates on an interfaceredistribute Redistribute information from anotherrouting protocolrouter-id Router-id for the OSPF processsummary-address Configure IP address summariestimers Adjust routing timersWEC8500/configure/router/ospf 2# network ?A.B.C.D Network numberA.B.C.D/M OSPF network prefixConfiguration using Web UIIn the menu bar of , select and then select the < Network> menu in the sub-menus.The OSPF initial window is shown below.
