Ver.CHAPTER 7. WLAN Additional Services© SAMSUNG Electronics Co., Ltd. page 255 of 4962600-00FK1RGA4 3.0Parameter Descriptionstation-and-ap-Use the both configured AP and station MAC and itis captured only when all the MAC information is matched.raw-ap-only-Capture the CAPWAP packet of configured AP MAC.Starting ServiceYou must start the remote packet capture service to connect to a device using a programthat supports the remote packet capture protocol on a remote PC.The related commands are given below.APC/configure/pcap# start-serviceRetrieving Configuration InformationUse the ‘show pcap current-config’ command to retrieve the remote packet captureconfiguration information.APC# show pcap current-config- Current status : Idle- Filtering mode : station-only- Configured AP’s MAC InformationNo. MAC Addr. Filtering Matched CountInbound Rate Outbound Rate===== ===================== =========== ============================================= ================1 F4:D9:FB:23:66:00 --------> ON 00.0 0.0ID Prf. AP Name IPv4 Addr------ ----------- ----------------------- ---------------2 ap_2 AP_f4d9fb236600 10.10.10.20- Configured Station's MAC InformationNo. MAC Addr. Filtering Matched CountInbound Rate Outbound Rate===== ===================== =========== ============================================= ================1 78:47:1D:C5:4C:85 OFF <------- 00.0 0.0AP WN SSID IPv4 Addr---- ---- --------------------------- ---------------2 2 Ajay_2_2_4G 20.20.20.302 FC:A1:3E:47:59:E7 OFF <------- 00.0 0.0AP WN SSID IPv4 Addr---- ---- --------------------------- ---------------2 2 Ajay_2_2_4G 20.20.20.25WEC8500#
