Ver.CHAPTER 3. Data Network Function© SAMSUNG Electronics Co., Ltd. page 96 of 4962600-00FK1RGA4 3.0After selecting a PROCESS ID that a user will use, select an interface to apply.Among the interface items displayed on the screen, configure the interface that a user wants.3.4.5.11 Interface General ConfigurationConfiguration using CLIUnlike other OSPF configurations, the interface general does not enter into the OSPF mode.Perform related configuration at the interface that a user wants. Therefore, the CLIconfiguration is as follows:1) Go to configure interface configuration mode of CLI.WEC8500# configure terminalWEC8500/configure#WEC8500/configure# interface ge22) The items for detail configuration are as follows:WEC8500/configure/interface ge2# ip ospf ?address Address of interfaceauthentication Enable authenticationauthentication-key Authentication password (key)cost Interface costdatabase-filter Filter OSPF LSA during synchronizationand floodingdead-interval Interval after which a neighbor isdeclared deaddisable Disable OSPFhello-interval Time between HELLO packetsmessage-digest-key Message digest authentication password(key)
